Weboldalunk használatával jóváhagyja a cookie-k használatát a Cookie-kkal kapcsolatos irányelv értelmében.
Menü
Ár:
12.679 Ft (9.984 Ft + ÁFA)
Menny.:db

Monster Arduino Moto Shield VNH2SP30 léptetőmotor verzérlő 30A

Ár:
12.679 Ft (9.984 Ft + ÁFA)
Menny.:db
Cikkszám: EHGS01381
Elérhetőség: Raktáron
Várható szállítás: 2022. december 12.

Leírás és Paraméterek

Dual VNH2SP30 Monster Moto Shield Module Stepper Motor Driver 30A16V For UNO

This is essentially a ramped up version of our Ardumoto motor driver shield. 

For this monster shield we've replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. 

We've also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! 

The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires. 

Note:

*When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However,when using the board at currents up to 6A the chips will barely become noticeably warm. 

Maximum current rating: 30 A. 

Practical Continuous Current: 14 A. 

Current sensing available to UNO analog pin. 

MOSFET on-resistance: 19 mΩ (per leg). 

Maximum PWM frequency: 20 kHz. 

Over temperature protection, over-voltage and under-voltage protection.